Half Landing
A stone spiral stair seen from below, winding up to a small round light.

Stairs in steel, oak and stone. Made in Sheffield since 1987.

HalfLanding

Nobody notices a good stair. Make one step 5 mm taller than the rest and people will trip on it for the next hundred years. So we measure on site twice, build the whole flight in the workshop, and only then take it apart and bring it to you.

We don't keep stock sizes. Your floor isn't a stock size either.

Every flight stands up in our Neepsend workshop before it leaves. You're welcome to walk on it.

Ourstairs

  • 8 mm plateOne sheet, folded from floor to landing. It rings a little when you walk on it. Some people like that. If you don't, we can damp it.

  • 75 mm treadsEach tread is built into the wall at one end and hung from a steel rod at the other. Yes, it holds. We load every tread to 300 kg in front of you.

  • Repair before replaceWe only cut a new tread when the old one can't be saved. The dip in the middle took three hundred years to make, so we leave it there.

  • Allow four monthsMost of that time goes on the timber mould, which gets used once and burned. There is no quicker way that looks right from underneath.

Work out your stair

Drag the two blue dots. Set the floor height and how much room you have, and we'll give you the number of steps and the size of each one. This is the sum we do first on every job.

Risers
Each rise
Each going
Pitch
2 rises + going

Half landing

That's where a long stair lets you stop and turn round. You're about halfway down this page, so here are four we've built.

Oak treads coming out of a white wall, each hung on a thin steel rod.
Nether EdgeHouse

Sixteen treads, no stringer

The client wanted to see the window from the front door. Now they can.

Broad curved stone steps in hard side light.
HalifaxCivic

Town hall steps

Forty-one worn treads lifted, numbered and put back in the same order.

Black steel fire escape seen from below, flights crossing overhead.
Kelham IslandMill

Five storeys, outside

Galvanised in Rotherham, craned in on a Sunday when the road was shut.

A white oval stair seen from above, curling down to the ground floor.
LeedsOffices

The stair they kept

The lifts went in new. Everyone still takes this.

How a stair gets made

  1. Day 1

    Survey

    We measure every floor at both ends. Old houses are never level.

  2. Week 1

    Template

    A full-size hardboard stair goes in, so you can walk it before anything gets cut.

  3. Weeks 2–8

    Workshop

    Cutting, folding, welding, oiling. Mostly waiting for things to dry.

  4. Week 9

    Dry fit

    The whole flight stands up in the shop. We check every rise to 1 mm.

  5. Week 10

    Fit

    Usually two days. We take the dust sheets with us when we leave.

“We'd booked three days for the stair. It was in by two o'clock on the first.”
Site manager, Nether Edge