Val Sorda
--:--:--

LineControl

The control room of the Val Sorda Railway. One track, 63 km, fourteen stations. Every figure on this page comes from today's timetable, on Zurich time.

A short train crossing green pasture below a glacier.
A train curving along a snowy forest ledge, seen from a carriage window.
A long train rounding a curve on a white, treeless pass.
A train on a curve below a high glacier valley.
Km / altitude
Air now
Next train

Line status

    Train log

      Our station clocks stop at the top of every minute and wait for the signal. It keeps all fourteen together.

      The chart

      Time runs left to right, distance bottom to top. Each line is one train. Steep means moving, flat means waiting. Where two lines cross, there had better be a loop.

      Up to Sorda PassDown to Sorda BadPassing loopTap a line to pick a train

      The climb

      812 m to 2,091 m. The stretch from Alp Grisch to Furcletta is too steep for wheels alone, so the trains go onto the rack. Going down, they brake on their motors and send power back up the wire to whoever is climbing.

      Departures

      TimeTrainToTrackStatus
      A curved stone viaduct among snowy trees.

      Why it's all on one track

      In 1903 there was money for one. So two trains can only pass each other at a loop, and we have four.

      The loops sit exactly thirty running minutes apart. That puts every crossing on the hour or the half hour, and the whole line repeats every sixty minutes.

      If one train runs late, the other sits in the loop and waits. That's most of this job.

      A red signal beside a snow-covered track.